Ik heb naast mijn 3600XLT een SDS200E. Deze is wel redelijk te vergelijken met de SDS100E Ik ben zeer tevreden maar je merkt wel dat hij wat trager is met scannen. Als je lange lijsten hebt ga je zeker uitzendingen missen. De ontvangst is prima. Wel heb ik het idee dat hij moeite heeft met het oppikken van de zwakkere analoge uitzendingen. Digitaal is hij beter dan de 3600XLT.
De SDS200E heeft een birdie op marifoon kanaal 0, de SDS100E volgens mij ook. Mocht je naar de KNRM willen luisteren, dan is dat wel een dingetje.
Traag scannen kan voorkomen als je 1 of meer filters op AUTO hebt staan. Filters kun je instellen per Department in Sentinel. Als je niet weet wat je moet kiezen zet je de filters op OFF.
----------
Hoe zat het ook al weer met de filters in de SDSx00E scanners, bij deze een beschrijving:
It's bandpass. It's the high IF filter at around 250MHz that's 10MHz wide.
At the OFF setting it works as any other filter in Unidens scanners and pass frequencies +/-5MHz around the monitored frequency.
NORMAL are an IF frequency shift of +5MHz in reference to the filters bandpass frequency so that it doesn't pass any frequencies, or only a narrow range, above the monitored frequency, but pass all frequencies 10MHz below.
INVERT are the opposite of that and pass everything 10MHz above the monitored frequency and nothing below it.
WIDE NORMAL only switch the IF filter halfways, so it will pass frequencies within 2MHz above and 8MHz below the monitored frequency.
WIDE INVERT are the possite with passband of 2MHz below and 8MHz above the frequency.
So there is no more narrower or more wider filters, the whole passband are just shifted more or less at either side, a common function in shortwave receivers.
What filter setting that works best to use are dependent of where the strongest interferencies are at the current unique location and are often an excersise of trial and error and are also dependent of what frequencies that are monitored. As the filter settings are defined for a whole site, or department, that might have a wide spread of different frequencies, it could be that one single setting does not work to be used for all frequencies at a site or department.