Dit staat in de Manual van Proscan
Before setting up the scanner, a cable should be connected from the scanner to the computer.
Using a RS-232 Cable
1.If connecting to a scanner port that doubles as a GPS port then a null modem adapter or cable is required. Otherwise use a
RS-232 straight through cable.
Using a USB Converter Cable
1.Connect the cable from the scanner to the computer.
2.Install the USB Converter driver.
3.Check the Windows Device Manager to see if the driver is installed correctly and is working.
4.Note the port assignment shown in the Device Manager.
Set the Port number and Baud Rate
1.Go to the scanner menu and find the port options. Some scanners have the port options in the GPS or Location section, other
scanners do not allow configuration.
2.Set the baud rate to the highest baud rate listed.
3.Go to the Menu --> Comm. Port.
4.Set the baud rate to match the scanner baud rate.
5.Set the Port to the same shown in the Windows Device Manager.
ProScan should now be communicating with the scanner's and the virtual display should come to life resembling the scanners
display.
Grt. Gu
