Using Batteries (BCD436HP Only)
You can power your BCD436HP using three alkaline or rechargeable AA batteries. This is no switch for battery selection.
Note: Batteries are required in the scanner for the replay and recording features to work.
1. Install 3 AA batteries, matching the polarity symbols (+ -).
2. Replace the cover.
When battery icon flashes and the scanner beeps every 15 seconds, replace or recharge the batteries.
Caution: There is no switch for the battery type. Never attempt to charge non-rechargeable batteries.
The scanner has a built-in circuit that lets you recharge rechargeable batteries while they are in the scanner.
When the scanner is turned on, the scanner will not charge the batteries.
When the scanner is turned off, the scanner will charge the batteries.
Plug the USB cable into the scanner when the scanner is off and "Battery Charge" - "Start Charging? Yes = "E"/ No = "." will display. Press E/yes.
The scanner displays “Normal Charging” and charges the batteries according to the "Set Charge Time" setting.
When charging is finished "Charge Complete" will be displayed.
http://new.marksscanners.com/536/436_536.shtml#introDe handiger te lezen handleiding voor de BCD436HP is vrijwel gelijk aan de BCD3600XLT. Het verschil zit vooral in het bereik van de verschillende banden 😉
Je 3600XLT laadt de batterijen maximaal 14 uur op. Mocht de 3600XLT tijdens het opladen te warm worden dan zet hij zichzelf uit (stopt dus ook met opladen).