Het Scannerforum
Scannersoftware => PDW => Topic gestart door: SBS01 op 30 november 2020, 17:59:24
-
Hi
I've been trying to run PDW through Virtualbox with an XP SP3 VM. While everything installs correctly and the slicer install seems to settle in correctly on the right COM port, i cannot get the application to get data from the the slicer. I confirmed that the COM port is working using another device that is controlled via the COM port and it was flawless.
Has anyone had any success using a VM to run this program?
Thanks
-
What kind of 'slicer' do you use?
-
Yours :)
-
2-level, 4-level, RS-232, USB?
-
Sorry, 4-Level
-
Image of config: https://ibb.co/xMhvBDG
-
For the 2 and 4-level interfaces, PDW needs direct hardware access to the serial port, since the port is used in a non-standard way. I.e. it doesn't observe the standard RS-232 protocol.
Using a virtual machine introduces a hardware abstraction layer, where direct access to the serial port hardware is not possible. So, it's not going to work.
-
Thanks for this information, I guess I'll be building a little XP PC for this monitoring. :)